Home › Fix it › Module or device offline
Fix it

Module or device offline

LAN, bus or combus module dropped off. Expanders, readers, keypads, RF receivers.

Quick fix

  1. Look at the module's LEDs. They usually tell you exactly what's wrong (table below).
  2. Meter power at the module. Should be 11–14 V DC.
  3. Check A/B (data) and 0V are connected at both ends and not swapped.
  4. Check the module address. Duplicate numbers are the classic after-swap fault.
  5. Re-enrol or re-scan modules if you've added, removed or replaced one.

Draft. Not yet checked on site. Confirm against the manual. Report an error

Inner Range LAN module LEDs

On Inner Range LAN modules (Integriti, Inception, Concept), the two LAN LEDs (often L1/L2 or RX/TX):

LEDs Means
Both on Not addressed. Check 0V, A and B
L1 off, L2 on Module type unknown. Update controller firmware
L1 flashing, L2 on Duplicate module number
Both flashing Module number too high for the controller
L1 on, L2 off Too many modules

Module number is set on DIP switches 1–7 (binary value + 1). Switch 8 off.

Inner Range LAN wiring

  • Twisted pair, A and B in parallel, 0V to every module. Shield earthed at one end only.
  • 1500 m max from the controller to any module.
  • Integriti's LAN is self-terminating. Remove termination links from old Concept 3000/4000 modules on an Integriti LAN.
  • Meter A to B: 470 Ω or less suggests a short or a terminated old module.
  • Never join two + supplies together.

Other panels

  • Interlogix NX: enter then exit program mode to re-enrol. The Service LED shows if an enrolled module goes missing.
  • Risco LightSYS: run the bus test. 97% or lower means a bus problem. Check wiring and DIP switches. For comms problems, add 2k2 resistors across the data terminals at each end.
  • Tecom Challenger: check poll errors, and reset the counts once the LAN is clean so new errors stand out.
  • Paradox EVO: remove AC and battery before connecting a module. Use shielded cable in noisy spots, shield grounded at the panel only.

Related

Keypad dead or blank
Still stuck? Ask TechMate

Checked Nov 2026 · Report an error