Home › Fix it

What's it doing?

Pick the symptom. Each one starts with the quick fix.

Alarm

Keypad dead or blankKeypad has no display, no beeps, or shows a bus or comms error.Locked out of an alarm panelTakeover or lost installer code. The legit ways back in, by brand.Low battery won't clearPanel still says low battery. Tired battery or a charging fault?Mains faultMAINS light on, keypad beeping. Usually the plug pack or power point.Module or device offlineLAN, bus or combus module dropped off. Expanders, readers, keypads, RF receivers.Not reporting to monitoringComms fail, line fault, or the monitoring centre isn't getting signals.Siren won't stopSiren going and the customer's losing it. Shut it up safely, then find out why.Won't armCustomer can't set the alarm. Nearly always an open zone or a fault blocking arming.Zone won't sealZone open or tampered with nobody there. Detector, cable or EOL setting?

CCTV

App won't connectCustomer can't see cameras on their phone. Usually the NVR's lost internet or the cloud setting.Bad picture at nightWhite haze, glare or blur once IR kicks in. Almost always reflection.Locked out of an NVRNobody knows the admin password. The legit ways back in for Hikvision, Dahua and Uniview.NVR can't see camerasCamera offline, no video or password error. Power, network or password?NVR hard drive errorHDD error, no recording, or "uninitialised". Format, replace, or a full drive?
Not listed? Ask TechMate