Home › Fix it › Won't arm
Fix it

Won't arm

Customer can't set the alarm. Nearly always an open zone or a fault blocking arming.

Quick fix

  1. Look at the keypad for an open zone. Close it, or check it with the customer before isolating.
  2. Look for a fault light (mains, battery, tamper, comms). Some panels won't arm with a fault active.
  3. Clear the alarm memory after a previous alarm.
  4. Right user, right area? The code may not have rights to that area.
  5. Still won't? See the fault guide for whatever's showing.

Draft. Not yet checked on site. Confirm against the manual. Report an error

Common blockers

  • Open zone: window, door, PIR seeing movement, or a zone that won't seal. See Zone won't seal.
  • Faults: mains, battery, tamper and comms faults can stop arming, depending on how the panel's programmed.
  • Tamper: detector lid, siren tamper or panel lid open.
  • Unsealed at exit end: on Ness, a zone open at the end of exit time gets auto-excluded with a 2-second siren. Repeated warnings point to a faulty detector.

Isolate or fix?

Isolating gets the customer armed tonight, but tell them in writing the zone's out, and come back to fix it.

Related

Zone won't sealMains faultLow battery won't clearSiren won't stop
Still stuck? Ask TechMate

Checked Nov 2026 · Report an error