Home › Fix it › Siren won't stop
Fix it

Siren won't stop

Siren going and the customer's losing it. Shut it up safely, then find out why.

Quick fix

  1. Disarm with a valid code. That stops most alarms.
  2. Still going while disarmed? It's a 24-hour zone: siren tamper, box tamper or panic. Find the tamper.
  3. No code? Disconnect the siren at the panel terminals so you can work. Power down first.
  4. Old panel just powered up? It may need a new battery and be sounding on tamper. Get into programming, or disconnect the siren while you sort it.
  5. Once it's quiet, read the alarm memory to see which zone started it.

Draft. Not yet checked on site. Confirm against the manual. Report an error

Sounding again after you leave programming

Inner Range Inception: if sirens kick in after service mode ends, there are armed areas with unsealed inputs, tampered inputs, or a module or cabinet tamper. Fix those before you finish.

Siren time

Ness D8x defaults to 5 minutes (P29E). Longer can breach local noise rules. If the customer complains it runs too long, check the siren time, not just the siren.

External siren tamper

A siren that won't stop with the panel disarmed is very often the external siren's tamper: lid off, cable damaged, or a dead siren battery in a self-powered siren.

Related

Won't armLocked out of an alarm panel
Still stuck? Ask TechMate

Checked Nov 2026 · Report an error