Home › Interlogix › Interlogix NetworX NX-4 / 6 / 8 / 8E
Interlogix · Alarm panel

Interlogix NetworX NX-4 / 6 / 8 / 8E

Defaulting and the enrol trick that fixes most module faults.

Quick fix

  1. Added, removed or swapped a keypad or module? Enter then exit program mode. The panel enrols everything (about 12 seconds).
  2. Service LED on after that = an enrolled module isn't talking. Check its wiring and address.
  3. Factory default: from program mode, enter the default sequence ending in #. Three beeps, about 6 seconds.
  4. During enrolment codes aren't accepted and a siren may chirp for a second. That's normal.

Draft. Not yet checked on site. Confirm against the manual. Report an error

Notes

  • NX panels are discontinued. Parts still turn up, but quote a replacement if the board's failing.
  • Hills Reliance XR can use some NX bus devices, with limited function.
Manuals & downloads

Related

Module or device offlineKeypad dead or blankLocked out of an alarm panel
Still stuck? Ask TechMate

Checked Nov 2026 · Report an error