Home › Bosch › Bosch Solution 2000 / 3000
Bosch · Alarm panel

Bosch Solution 2000 / 3000

Programming, defaulting, EOL and fault analysis.

Quick fix

  1. Into programming: disarm, enter the installer code then #. Icon codepad: two beeps, STAY and AWAY flash.
  2. Out: 958 exits without saving. 960 saves, exits and resets.
  3. Faults: hold 5 for three seconds for fault analysis.
  4. Default: installer command 961, or the default button on the board (unless disabled at location 0900).
  5. EOL: location 266. Default is split 3k3 / 6k8.

Draft. Not yet checked on site. Confirm against the manual. Report an error

Fault analysis groups

Group Check
System fault Battery, date/time, RF receiver, outputs, phone line, power supply, onboard tamper
RF low battery / keyfob low battery Battery in that device
Zone tamper Detector lid, cable, tamper resistor
Sensor watch Detector hasn't triggered for the set time. Masked or dead
RF sensor missing Out of range or flat
Communication fail Receiver path or IP module
Output / codepad fail Codepad wiring, address clash, output wiring

Export the config with A-Link Plus before you default. Defaulting wipes everything.

Specs at a glance
Codepads
Up to 4 (incl. touchscreen), DIP-switch addressed
Battery
12 V 7 Ah
Plug pack
18 VAC, 1.33 A
Current
AUX < 900 mA, bus < 900 mA, total < 1100 mA
Software
A-Link Plus (also for IP and email setup)
Manuals & downloads

Related

Mains faultLow battery won't clearZone won't sealNot reporting to monitoring
Still stuck? Ask TechMate

Checked Nov 2026 · Report an error